Alara Resources Limited

Published : June 13th, 2016

Further Information - Mineralisation at Al Hadeetha Project

( 0 vote, 0/5 ) Print article
  Article Comments Comment this article Rating Follow Company  
0
Send
0
comment

Further Information - Mineralisation at Al Hadeetha Project

Microsoft Word - 20160613 AUQ ASX Announcement - Further Information on Oman Project Update

Alara Resources Limited

A.B.N. 27 122 892 719

Level 11, 216 St Georges Tce Perth WA 6000, Australia

GPO Box 2517

Perth WA 6831

Telephone | +61 8 9481 0389

Facsimile | +61 8 9463 6103

Web | www.alararesources.com Email | [email protected]

ASX/MEDIA RELEASE

Tuesday, 14 June 2016

FURTHER INFORMATION REGARDING

HIGH GRADE COPPER & GOLD MINERALISATION AT THE AL HADEETHA PROJECT

Further to the ASX Announcement of 8 June 2016, and in accordance with ASX listing rule 5.7, Alara Resources Limited (ASX: AUQ) (Alara or Company) is pleased to provide Appendices containing additional information on the copper and gold mineralisation at the Al Hadeetha Project in Oman.

Appendix 1 contains sampling techniques, data and material drill-hole information (as per sections 1 and 2 of Table 1 of JORC Code 2012) relating to three drill holes. Of these three drill hole intersections, complete results of only one (WH16RD012) were announced on June 8, 2016. Announcement of intersections from the other two drill-holes is still pending.

The drill hole primary mineralised intersections announced on 8 June, had a 0.2% Cu cut-off grade which is a natural break/sharp change is assay results differentiating between mineralised and non-mineralised intersections. Grade cut off at 0.2% Cu is also a reasonable economic cut-off to delineate potential mineralisation. The length is reported as down-hole length in a vertical hole. True thickness will be calculated at resource interpretation stage. The grade was reported as down-hole length weighted average grade.

The remaining results shall be reported after completion of drilling, along with full analyses of samples which is expected by the end of the month.

Appendix 2 contains Washihi JORC Resource table, plus sampling techniques, data and exploration results (as per sections 1, 2 and 3 of Table 1 of the JORC Code 2012) relating to the copper-gold Resource at Al Hadeetha Project's Washihi deposit. The information in the JORC Resource table was prepared and first disclosed under the JORC Code 2004. It has now been updated to comply with the JORC Code 2012 on the basis that the information has not materially changed since it was last reported.

ASX Code | AUQ

DRILL HOLE COLLAR TABLE

APPENDIX 1

BH_ID

COLLAR EASTING

COLLAR NORTHING

COLLAR RL (M)

AZIMUTH

(⁰)

DIP

(⁰)

133MM RC DRILLING (M)

HQ3 CORE DRILLING (M)

END OF HOLE DEPTH (M)

WH16RD012

602184

2517810

457

0

90

0.0 TO 108

NIL

108

WH16RD013

602190

2517894

457

0

90

0.0 TO 89.3

89.3 TO 130.5

130.5

WH16RD014

602270

2517691

463

0

90

0.0 TO 109.5

NIL

109.5

JORC 2012 TABLE -1: SECTION 1: SAMPLING TECHNIQUES AND DATA

Criteria JORC Code explanation Commentary

Sampling techniques

  • Nature and quality of sampling (e.g. cut channels, random chips, or specific specialized industry standard measurement tools appropriate to the minerals under investigation, such as down hole gamma sondes, or handheld XRF instruments, etc.). These examples should not be taken as limiting the broad meaning of sampling.

  • Include reference to measures taken to ensure sample representivity and the appropriate calibration of any

    • Diamond drilling and reverse circulation (RC) drilling were used to obtain samples for geological logging and assaying.

    • RC drill holes are sampled at 1m intervals and split using a cone splitter attached to the cyclone to generate a split of ~3 or more kg.

    • Diamond core was halved with a Diamond saw and generally sampled at 1m intervals with shorter samples at geological contacts.

    • Sampling was systematic. Samples selected for sampling and subsequent sample preparation and chemical analysis are based on geological logging with sample breaks after appropriate sampling interval (average length of sample is 1m) or at rock unit contact.

    • The samples were checked against sample submittal form, dried and crushed to 70% -2mm. then rotary split off up to 250g; the split was pulverized to better than 85% passing a 75 micron. The resultant pulps were then analysed. Pulverizer bowls were carbon steel. The

Criteria JORC Code explanation Commentary

measurement tools or systems used. pulverized samples were analysed for Copper digested by four acid digestions followed by

  • Aspects of the determination of ICP-OES; for Gold using 50g Fire Assay followed by AAS. After pulverization, lab stored all mineralization that are Material to the the rejects for future use. Pulverization at laboratory was controlled by Grind checks. Public Report.

  • In cases where 'industry standard' work has been done this would be relatively simple (e.g. 'reverse circulation drilling was used to obtain 1 m samples from which 3 kg was pulverised to produce a 30 g charge for fire assay'). In other cases more explanation may be required, such as where there is coarse gold that has inherent sampling problems. Unusual commodities or mineralization types (e.g. submarine nodules) may warrant disclosure of detailed information.

DrillingDrill type (e.g. core, reverse circulation,RC Drilling was conducted using a reverse circulation rig with 115mm to 133mm face-sampling

techniques open-hole hammer, rotary air blast, auger, bits.

Bangka, sonic, etc.) and details (e.g. core Diamond drilling was conducted only in holes where RC drilling was difficult to proceed or due to

diameter, triple or standard tube, depth of encountered ground water in the hole. Diamond drilling was in HQ3 drill diameters.

Diamond tails, face-sampling bit or other type, whether core is oriented and if so, by what method, etc.).

Drill sampleMethod of recording and assessing coreRC samples were weighed on a regular basis but no sample recovery issues were encountered

recovery and chip sample recoveries and results during the drilling program.

assessed. Overweight samples (>3kg) were re-split with portable riffle splitter to about 2Kg.

Criteria

JORC Code explanation

Commentary

  • Measures taken to maximize sample recovery and ensure representative nature of the samples.

  • Whether a relationship exists between sample recovery and grade and whether sample bias may have occurred due to preferential loss/gain of fine/coarse material.

Drill core recoveries from Diamond drilling were recorded following standard logging practice by recording drill hole run length and recovered length. Drill core recoveries were recorded based on run and sample length.

Logging

  • Whether core and chip samples have been geologically and geotechnically logged to a level of detail to support appropriate Mineral Resource estimation, mining studies and metallurgical studies.

  • Whether logging is qualitative or quantitative in nature. Core (or costean, channel, etc.) photography.

  • The total length and percentage of the relevant intersections logged.

RC Chips from drill holes were geologically logged following standard operating procedure. Basic geotechnical logging has been done wherever core drilling was conducted.

The entire drill holes length was logged.

Sub- sampling techniques and sample preparation

  • If core, whether cut or sawn and whether quarter, half or all core taken.

  • If non-core, whether riffled, tube sampled, rotary split, etc. and whether sampled wet or dry.

  • For all sample types, the nature, quality and appropriateness of the sample preparation technique.

RC drill holes are sampled at 1m intervals and split using a cone splitter attached to the cyclone to generate a split of ~3 or more kg.

Diamond core was halved with a Diamond saw and generally sampled at 1m intervals with shorter samples at geological contacts.

RC sample splits (1 to 2kg) are pulverized to 85% passing 75 microns.

Diamond core samples are crushed to 70% passing 2mm and then pulverized to 85% passing 75 microns.

Rotary split of 250g was pulverized to better than 85% passing 75 micron.

Read the rest of the article at www.publicnow.com
Data and Statistics for these countries : Australia | Georgia | Oman | All
Gold and Silver Prices for these countries : Australia | Georgia | Oman | All

Alara Resources Limited

CODE : AUQ.AX
Follow and Invest
Add to watch list Add to your portfolio Add or edit a note
Add Alert Add to Watchlists Add to Portfolio Add Note
ProfileMarket
Indicators
VALUE :
Projects & res.
Press
releases
Annual
report
RISK :
Asset profile

Alara Resources LTD is based in Australia.

Alara Resources LTD is listed in Australia. Its market capitalisation is AU$ 7.1 millions as of today (US$ 4.4 millions, € 4.0 millions).

Its stock quote reached its highest recent level on January 14, 2011 at AU$ 0.48, and its lowest recent point on June 05, 2015 at AU$ 0.01.

Alara Resources LTD has 595 689 984 shares outstanding.

Your feedback is appreciated, please leave a comment or rate this article.
Rate : Average note :0 (0 vote) View Top rated
 
Project news of Alara Resources Limited
8/12/2016Project Updates
Corporate news of Alara Resources Limited
8/3/2016Closure of Renounceable Rights Issue
7/15/2016Dispatch of Prospectus
7/12/2016Letter to Ineligible Shareholders
7/8/2016Prospectus - Renounceable Issue
7/8/2016Letter to Optionholders - Renounceable Issue
7/8/2016Further Information & Project Update - Al Hadeetha Project
6/13/2016Further Information - Mineralisation at Al Hadeetha Project
6/8/2016Oman Project Update
5/31/2016Project Updates
5/19/2016Khnaiguiyah Zinc-Copper Project - Legal Update
5/11/2016Oman Project Update
4/13/2016Board Appointment and Appendix 3X
4/1/2016Feasibility Study Update
1/18/2016Option Expiry
12/23/2015Potential Breakthrough on Khnaiguiyah Project
12/18/2015Project Update - Oman
12/1/2015Results of Meeting
11/24/2015Recent Developments in Saudi Arabia
11/18/2015Listing Rule Compliance
Comments closed
 
Latest comment posted for this article
Be the first to comment
Add your comment
AUSTRALIA (AUQ.AX)
0.012+0.00%
AUSTRALIA
AU$ 0.012
04/07 11:25 -
0%
Prev close Open
0.012 0.012
Low High
0.012 0.012
Year l/h YTD var.
0.012 -  0.018 -20.00%
52 week l/h 52 week var.
0.012 -  0.030 -57.14%
Volume 1 month var.
155,078 -%
24hGold TrendPower© : -31
Produces
Develops
Explores for
 
 
 
Analyse
Interactive chart Add to compare
Interactive
chart
Print Compare Export
You must be logged in to use the porfolio and watchlists (free)
Top Newsreleases
MOST READ
Annual variation
DateVariationHighLow
2020-29.41%0.020.02
2019-26.09%0.040.01
2018-23.33%0.030.02
201766.67%0.030.01
201638.46%0.030.01
 
5 years chart
 
3 months chart
 
3 months volume chart
 
 
Mining Company News
Plymouth Minerals LTDPLH.AX
Plymouth Minerals Intersects Further High Grade Potash in Drilling at Banio Potash Project - Plannin
AU$ 0.12-8.00%Trend Power :
Santos(Ngas-Oil)STO.AX
announces expected non-cash impairment
AU$ 4.42+2.08%Trend Power :
Oceana Gold(Au)OGC.AX
RELEASES NEW TECHNICAL REPORT FOR THE HAILE GOLD MINE
AU$ 1.76-0.85%Trend Power :
Western Areas NL(Au-Ni-Pl)WSA.AX
Advance Notice - Full Year Results Conference Call
AU$ 1.94-2.52%Trend Power :
Canadian Zinc(Ag-Au-Cu)CZN.TO
Reports Financial Results for Q2 and Provides Project Updates
CA$ 0.12+4.55%Trend Power :
Stornoway Diamond(Gems-Au-Ur)SWY.TO
Second Quarter Results
CA$ 0.02+100.00%Trend Power :
McEwen Mining(Cu-Le-Zn)MUX
TO ACQUIRE BLACK FOX FROM PRIMERO=C2=A0
US$ 0.74+5.71%Trend Power :
Rentech(Coal-Ngas)RTK
Rentech Announces Results for Second Quarter 2017
US$ 0.20-12.28%Trend Power :
KEFIKEFI.L
Reduced Funding Requirement
GBX 0.83+7.79%Trend Power :
Lupaka Gold Corp.LPK.V
Lupaka Gold Receives First Tranche Under Amended Invicta Financing Agreement
CA$ 0.01+100.00%Trend Power :
Imperial(Ag-Au-Cu)III.TO
Closes Bridge Loan Financing
CA$ 1.33+3.10%Trend Power :
Guyana Goldfields(Cu-Zn-Pa)GUY.TO
Reports Second Quarter 2017 Results and Maintains Production Guidance
CA$ 0.31+8.77%Trend Power :
Lundin Mining(Ag-Au-Cu)LUN.TO
d Share Capital and Voting Rights for Lundin Mining
CA$ 5.41+4.95%Trend Power :
Canarc Res.(Au)CCM.TO
Canarc Reports High Grade Gold in Surface Rock Samples at Fondaway Canyon, Nevada
CA$ 0.04+0.00%Trend Power :
Havilah(Cu-Le-Zn)HAV.AX
Q A April 2017 Quarterly Report
AU$ 0.08-1.18%Trend Power :
Uranium Res.(Ur)URRE
Commences Lithium Exploration Drilling at the Columbus Basin Project
US$ 6.80-2.86%Trend Power :
Platinum Group Metals(Au-Cu-Gems)PTM.TO
Platinum Group Metals Ltd. Operational and Strategic Process ...
CA$ 2.03+9.73%Trend Power :
Devon Energy(Ngas-Oil)DVN
Announces $340 Million of Non-Core Asset Sales
US$ 8.80+5.01%Trend Power :
Precision Drilling(Oil)PD-UN.TO
Announces 2017Second Quarter Financial Results
CA$ 8.66-0.35%Trend Power :
Terramin(Ag-Au-Cu)TZN.AX
2nd Quarter Report
AU$ 0.04+9.38%Trend Power :